I'm having problems trying to send several nodes to a nodequeue and can't seem to get it to work.

Using views bulk operations, I click the checkboxes next to the node on the views page and select the operation "add to nodequeues" and click execute. I then select the desired queue and click next, and perform the action. It says that the action has been completed successfully and that the action has been performed on the node.

When I check out the nodequeue, it says that it's empty. I have just begun using nodequeue and bulk operations, so any advice would be appreciated. I have a smartqueue from taxonomy that I tried sending the nodes to, as well as a nodequeue that I created and both are empty.

I am also going to post this issue in the views bulk operations module, as i'm not sure where the best place for it is.

Thanks!

Comments

jaron’s picture

jaron commented

Did you ever figure out a solution to this problem? I'm having the same issue.

Thanks.

amateescu’s picture

amateescu commented
Category: task » support
Status: Active » Closed (cannot reproduce)

Cannot reproduce this issue with 7.x-2.0-beta1. Are you sure the node's content type is enabled for that nodequeue?

alauddin’s picture

alauddin commented
Issue summary: View changes

I experienced the same issue, with 7.x-2.0-beta1, solved it by disabling the check box in VBO views for enqueue...executing it directly works.

[x] Add to Nodequeues
[ ] Enqueue the operation instead of executing it directly