If not specified, Imagefield Assist filter defines the width="" and height="" which results to a invisible picture in some browsers. The workarround for now is to define width and height explicitly / but i would rather avoid that.

CommentFileSizeAuthor
#1 imagefield_assist-height-width.patch775 bytesfranz

Comments

franz’s picture

franz
any
Location Montréal
commented
Status: Active » Fixed
StatusFileSize
new imagefield_assist-height-width.patch775 bytes

Thanks. Commited on dev. =)

Attached the patch for convenience.

Status: Fixed » Closed (fixed)

Automatically closed -- issue fixed for 2 weeks with no activity.

RonD’s picture

RonD commented
Status: Closed (fixed) » Active

Greetings, I re-opened this issue because the patch code above from franz was not in the the 6.x-1.0-beta3 version I downloaded from DO.

I located the lines in the version of the module I have at 1487 & 1488. After applying the changes in the patch to those two lines, FF and IE are now both working for me.

I also commented on issue #809676 just before I saw this issue.

No clue why the patch is not in the current module version but getting it in will close this issue again and close #809676.

franz’s picture

franz
any
Location Montréal
commented
Status: Active » Fixed

It is so because there was no officla release after the patch was commited. =(

Status: Fixed » Closed (fixed)

Automatically closed -- issue fixed for 2 weeks with no activity.